Technical specifications
Tube connector
Both 22mm conical male (elbow connection type 1) and 22mm conical female (elbow connection type 2) are available (in
compliance with ISO 5356-1). It’s used to connect an external ventilator tube.
Dead space information
Physical dead space is the empty volume of the mask to the end of the elbow. The dead space of the mask varies
according to cushion sizes but is less than 297ml.
Pressure range: 4-30cmH2O
Environmental conditions
Operating temperature: + 5 ℃ to + 40 ℃; Operating humidity, 15-95% relative humidity, non-condensing.
Storage and transport temperature: -20 ℃ to + 60 ℃; Storage and transport humidity: not exceeding 95% RH,
non-condensing .
External dimensions
S: 175.9mm (height) × 110mm (width) × 112.4mm (thickness)
M: 183.9mm (height) × 118mm (width) × 114.4mm (thickness)
L: 194.9mm (height) × 122mm (width) × 114.4mm (thickness)
The above external dimensions are for reference only. Goods in kind prevail!
Cleaning instructions
Cleaning the mask should be carried out before the first use and should be cleaned daily. Headgear should be cleaned
once a week, or if necessary, cleaned.
with warm soapy water to clean the mask and headgear, and avoid soaking over 10 minutes, To clean up the vent
with a soft brush.
Mask all parts of drinking water in addition to applications outside of the headgear rinse, and dry naturally in a
dark place. Before each use, make sure the mask is dry.
Headgear after cleaning rinses with water and placed in a place, away from direct sunlight to dry naturally.
Mask and breathing circuit cannot be exposed to direct sunlight place, this will accelerate the aging of the
product.
Mask before use, check for damage or wear (cracking, crazing, tears, etc), when necessary, discard and replace
the parts.
Note: Mask need to be asked for a daily cleaning when used.
Reviews
There are no reviews yet.